Logo

P184C Engine Trouble Code

Meaning of P184C engine trouble code is a kind of powertrain trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

P184C Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting
If one of these reasons for P184C code is occuring now you should check P184C repair processes.
Now don't ask yourself; What should you do with P184C code ?
The solution is here :

P184C Possible Solution:

P184C Engine

Gasoline engines use spark plugs to cause an explosion of fuel within the cylinder. In a properly timed engine, this explosion occurs at the proper moment to send the piston to the bottom of the cylinder and provide power to the drive shaft. If the plug wires are out of sequence, the explosion occurs at the wrong time. The improper timing of the explosion sometimes pushes the cylinder the wrong direction or interferes with the turning of the crank. As a result, the engine stutters or backfires, if it runs at all.

P184C Code Meaning :

P 1 8 4 c
OBD-II Diagnostic Powertrain (P) Trouble Code For Engine Fuel And Air Metering Engine Oil Temperature Sensor Malfunction Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

P184C OBD-II Diagnostic Powertrain (P) Trouble Code Description

P184C engine trouble code is about .

Main reason For P184C Code

The reason of P184C OBD-II Engine Trouble Code is Engine Oil Temperature Sensor Malfunction.

P184C code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.